Can I program the remote to my vehicle?

YES! Instructions are included and it will take 1 minute to program.

No tools, just follow a few basic steps.

Not sure if you vehicle has factory keyless entry?

Follow the Verification procedure:

1.   Close and lock all doors with the driver’s side power lock/unlock switch.
 
2.   Insert key into ignition and remove it from the ignition key cylinder at least six times
     within 10 seconds. Your Hazard Lamps will flash if you have performed this step
     successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this
     procedure is performed too fast, system will not enter programming mode.

If your hazard lamps FLASH then you have factory installed keyless entry.